Audio Processor Drawmer
Drawmer
Drawmer 1960 Mic Pre/Vacuum Tube Compressor
The Drawmer 1960 is a two channel unit with each channel comprised of a completely natural sounding "soft knee" vacuum tube compressor and an extremely low noise microphone pre-amplifier with switchable 48 volt phantom power. A further auxiliary instrumen
[Product Details...]
Drawmer 1961 Vacuum Tube Equalizer
Designed to complement the widely acclaimed Drawmer 1960 Mic Pre-Amp Vacuum Tube Compressor, the 1961 Vacuum Tube Equalizer combines low noise circuitry with no fewer than twelve active tube stages to provide two channels of exceptional equalization posse
[Product Details...]
Drawmer 1968 Mercenary Edition
The 1968 is a 1U Tube/FET ‘stereo bus’ compressor which by design delivers a transparent ‘open’ sound even during periods of heavy compression. Featured on both channels is a switchable ‘BIG’ mode which applies less processing to the fundamental low frequ
[Product Details...]
Drawmer 1969 Mercenary Edition
The 1969 Mercenary Edition is a new product that derives from a collaboration between two of the audio industry’s most established names, Drawmer (UK) and Mercenary Audio (USA). When Ivor Drawmer rose to the challenge of outspoken US producer/engineer ‘Fl
[Product Details...]
Drawmer Three-Sum Multi-Band Interface
The new Drawmer THREE-SUM opens up a whole new set of options allowing the engineer to split the audio into two or three bands and apply his or her own sonic signature to each part of the audio bandwidth. The THREE-SUM employs a high quality signal path c
[Product Details...]
Drawmer DA6 Balanced Distribution Amplifier
The Drawmer DA-6 is a six channel stereo (or twelve channel mono) distribution amplifier featuring XLR balanced inputs and outputs with optional transformer balancing where remote amplifiers and recorders are fed from separate power supplies.
[Product Details...]
Drawmer DL241 Auto Compressor
The introduction of the Drawmer DL241 Dual Channel 'Auto-Compressor' highlights the beginning of a new generation of dynamic processors which set new standards of sonic excellence. Its combination of features, displays and well designed control functions
[Product Details...]
Drawmer DL251 Spectral Compressor
The DL251 'Spectral Compressor', incorporates a variable 'Dynamic Spectral Enhancement' (D.S.E.) section which eliminates the problems associated with full band compressors by restoring the high frequency energy lost during the full band compression proce
[Product Details...]
Drawmer DL441 Quad Auto Compressor Limiter
The DL441 Quad Auto Compressor/Limiter captures four channels of Drawmer's innovative DL241 'Auto Compressor' in only 1U of rack space. The inclusion of new sophisticated 'automated' circuitry allows the engineer to precisely control both the dynamic rang
[Product Details...]
Drawmer DS201 Dual Noise Gate
The DS201 is a sophisticated dual channel noise gate incorporating a number of features pioneered by Drawmer, which are invaluable to the sound engineer, and not found on conventional noise gates.
[Product Details...]
Drawmer DS404 Quad Noise Gate
The DS404 Quad Noise Gate has been designed to the highest specification to complement the DS201 Dual Noise Gate, acknowledged as the 'industry standard' gate throughout the world. Recognizing that there are many general gating applications which require
[Product Details...]
Drawmer DS501 Power Gate
The DS501 is a sophisticated dual channel noise gate with fully tuneable 'Peak Punch' incorporating a number of features pioneered by Drawmer, which are invaluable to the sound engineer, and not found on conventional noise gates.
[Product Details...]
Drawmer DSL424 TwoPlusTwo Dynamics
The DSL424 provides the engineer with a 1U four channel comprehensive toolbox capable of solving the most complex dynamic problems. Incorporated in the 1U package are two industry standard frequency conscious noise gates and two soft/hard knee compressors
[Product Details...]
Drawmer LA12 Line Distribution Amplifier
The LA12 is a low noise, low crosstalk distribution amplifier with high bandwidth specification, developed specifically for 'real time' cassette duplication. As more and more facilities invest in this form of tape copying, the LA12 offers the efficient so
[Product Details...]
Drawmer MX30 Gated Compressor Limiter
The MX30 Gated/Comp/Limiter is a low cost professional quality dynamics processor containing some of the proprietary design circuitry used in the more expensive models in the Drawmer range.
[Product Details...]
Drawmer MX40 Punch Gate
The MX40 Punch Gate is a high performance, simple to use 1U four channel noise gate that offers the same extraordinary sonic character, ingenuity, and high technical specification that have made Drawmer the world standard in gating technology.
[Product Details...]
Drawmer MX50 De-Esser
The human voice is one of the most diverse signals ever encountered by engineers because it contains such large variations in level and harmonic structure. Getting the desired vocal sound can sometimes prove difficult. Setting the E.Q. to give the vocal s
[Product Details...]
Drawmer MX60 Front End One
The MX60 Front End One is a unique mic/line/instrument input channel in a single rack space providing high quality Drawmer processing prior to tape/hard disc recording.
[Product Details...]
Drawmer S3 Multi-Band Stereo Tube Compressor
The new S3 Stereo Three Band Tube Compressor incorporates the very latest in Ivor Drawmer designs and the aim from the very beginning was to create a ‘no technical compromise’ circuit using only the highest grade components.
[Product Details...]
Drawmer Six-Pack
The Drawmer Six-Pack represents the industry’s first dedicated multi-dynamics processor for surround mixing and continues Drawmer’s tradition of audio ‘workhorse’ products which will continue to perform time and time again - even in a rapidly changing au
[Product Details...]